- Detail
- Parameters
The FlyTower F3 board designed based OMNIBUS (BateFlight) FC and was highly integrated with OSD,BEC,4 in 1 BLHeli_S 30A/DShot 30A ESC and VTX(25/200/400mW). It gives you all the features what you need in FPV, which makes you easily get into FPV Racing.
Specification: User Manual
| PDB | Integrated | |
Battery Monitoring | Integrated | |
| FC Power | Integrated | |
| Operating Voltage | 2-4S Lipo | |
| Maximum continuous operating current | 4*30A | |
| Maximum instantaneous operating current | 4*35A(10S) | |
| Oneshort 125/42/Dshot 150/300/600 | YES | |
BlheliSuite Configurable | YES | |
| Firmware Vision | BLHeli S/Dshot 150/300/600 16.5 (L_H_00) | |
| Board Size | 36*36mm | |
| weight | 10g | |
| FC&VTX Board | Firmware Vision | BateFlight 3.1(OMNIBUS) |
| Configure | BetaFlight | |
| VTX Power | 25/200/400mW(MAX 800mW) | |
| CH | 40CH | |
| OSD Firmware | Bateflight OSD | |
| Video Camera Voltage | Any stand by 5V Video Camera | |
| Board Size | 36*36mm | |
| weight | 11.4g | |
| Black Ants FlyTower F3 | Any Board weight | 21.4g |
| total weight | 28.7g | |
| Installation height(Add air-cooling fin) | 15mm/20mm | |
| Screws | M3*18mm | |
| Recommended Rack Plate Thickness | Not more than 3MM (3mm above the appropriate extension of the screw) |
Feature:
Practical - Easy to access connectors
Configurable - Choose to use connectors
Stackable - Mount our 4 in 1 ESC
Compact - Only 36x36x15mm.(Add air-cooling fin MAX 36*36*20MM)
Weight - 28.7 grams and 2 stack boards
Professional - Symmetrical, Neat and Tidy and Easy to install in any racing drone
36x36mm board with 30.5mm mounting holes
STM32 F303 MCU, Runs Betaflight firmware(supported from v3.0)
SD card slot
Use MPU6000 as Acc & gyro Over SPI Bus
STM32 controls OSD chip over SPI in DMA mode, less CPU using, faster rate
Micro USB socket
1x 4pins JST-SH sockets (PPM, PWM, SERIAL RX, GPIO, ADC, 3V, 5V, GND)
The on-board pins are easily connected to our next 4 in 1 ESC &PDB board
Internal VTX (40CH) (25/200 / 400MW adjustable power video transmission)
1x 4pins JST-SH sockets with BUZZER & WS2811 RGB LED
1x 4pins JST-SH socket for Video & Audio transmission
1 IPX sockets easy connect the external antenna
4x 3 Pads for motor output
1x2 Pads for batter in easy solder
