Fly for Fun

• STEP 1: Install 2 pcs 3V CR2032(Battery not included, self purchase)

• STEP 2: Connect the winch and programmer with IST line(As picture)

• STEP 3: Use the wire as picture shows, one side connect programmer power input side, then connect the plug with your ESC

• STEP 4: Use a pin to turn on the programmer, then you can try the winch

• STEP 5: Use the sticker to decorate the winch as you wish

IMPORTANT NOTE: If the cable unspooled and will not rewind, try re-align frequency by press and hold both buttons of the controller simutaneously for about 10 seconds